1.Gas detection probe selection should be selected valve, pipe interface, outlet or easy to leak near the radius of 1 meter range, as close as possible, but do not affect other equipment operation, while avoiding high temperature, high humidity environment, to avoid the external Affect the possibility of splashing water, oil and causing mechanical damage.
2.Gas detection probe installation can be used roof roofing, wall installation or pipe installation, should ensure that the installation of solid and reliable, and should be considered easy to maintain, calibration.
3.Gas detection probe wiring should be used three-core shielded cable, a single wire diameter greater than 1 square millimeter, wiring shield must be grounded.
4.Gas detection probe should be installed when the sensor down, the lock nut should be fully tightened, the probe cover should be completely covered, with a screw tightened to meet the explosion requirements.
5.Gas detection probe should be wired in the case of power to determine the correct wiring after the power; should be determined in the scene without gas leakage, open the lid debugging probe.
contact info:Emily
Email:emily@huafankj.com
Whatsapp:+8618966920190